Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
take a mosfet.giv a dc voltage to its gate to bias it properly to be in deep saturation(giv 1v)and the ac voltage of the dc voltage source to some value.connect a load resistor.If u dont want noise due to resistor to be include use a G element.and perform noise analysis.sweep the frquency acc to your wish in noise analysis.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.