Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

No output from the enable pins....pls help

Status
Not open for further replies.

nirmal_rockin

Junior Member level 2
Joined
Aug 8, 2009
Messages
22
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
India
Activity points
1,452
hi this is the schematic for my line follower.. the problem is tat i don get any output from both the enable pins(pins 18 and 19 of the mc). due to wch the motor refuses to. run... nw i'm confused how to resolve this problem...
any one help pls...
i hav also attached the source code for the mc...
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top