Working on a USB to Serial Converter FT232RL and a bit confused about the pins. I know that Not Connected(NC) pins are represented by a cross sign but this Pin12 has no such symbol unlike others. Also there isn't any Global signal that i can see Connected to it. See the Attached Schematics here:
You are correct that an unconnected pin should have an X on it, this appears to be a connected (pin12) pin to me.
However the net cannot be seen, does ORCAD have the ability to change the colours of individual nets? If you have a look there and see if it's been disabled\made invisible or white.
You are correct that an unconnected pin should have an X on it, this appears to be a connected (pin12) pin to me.
However the net cannot be seen, does ORCAD have the ability to change the colours of individual nets? If you have a look there and see if it's been disabled\made invisible or white.