Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Neutral Point Clamped Three Level Inverter IGBT drive circuit design using IR2110

Status
Not open for further replies.

HanyHamed

Junior Member level 1
Junior Member level 1
Joined
Aug 21, 2015
Messages
18
Helped
1
Reputation
2
Reaction score
1
Trophy points
1
Location
UAE
Activity points
92
hello,
I am designing the IGBT drive circuit for NPC inverter. in principle, each phase module contains 4 IGBT in series and two clamping Diods. Each pair of IGBT is driven by IR2110 chip. in my design, each chip require 3 power supplies of + 15 volt. I need to review the design with whom can share the knowledge.

Hany
 

Thanks for your reply. my intension is not to discuss the theory of operation, I am focusing in implementing the IR2110 to build he IGBT drive. if you can find any post dealing with that issue you would offer me a great help

best regards
Hany
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top