Neeed MTB-230 LCD Driving codes via Microcontrollerfffffff

[crackerboy]

Neeed MTB-230 LCD Driving codes via Microcontroller

Hi,
I want to drive MTB-230 series 128x64pixels COG(Chip-on-Glass) LCD with 0.50mm Pitch FFC/FPC connector using a MCU!
Is there anyone has knowledge how to drive this LCD? I am looking especially for C code library for driving it.


Thanks for your interests... ;-)

Here is the datasheet of MTB-230 LCD manufacturer :http://www.lcd-modules.com/COG-graphic-modules.htm
Here is the datasheet of COG Driver IC (HT0313A): HT0313A.pdf
Here is the datasheet of MTB-230 LCD datasheet: NMTB-F000230FWHSGW-11A.pdf

 

[cl10greg]

You're going to want to look in the LCD driver chip datasheet. Under section 6 gives you interface options and tells about a serial or parallel mode for communication. Depending on your LCD background, you should be able to determine the communication and RAM commands to send to work with the device. If you are new to this then you are going to want to look into some application files to see how and where data is clocked into LCD screens to allow it to work.