Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Need to identify this connector ASAP!

Status
Not open for further replies.

rotorpixel

Newbie level 1
Newbie level 1
Joined
Feb 5, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
9
I've looked through catalog after catalog of connectors, but can't find either the male or female version of this connector anywhere! Does anyone have any ideas?

The pitch appears to be 2.54mm (0.1"), but the pin holes appear to be flat, rather than the typical square profile of header pins.

I just had a bit of a breakthrough, as I took the photos attached... it appears to say "ALEX" on the side of the connector, so I've just checked out www.alexconn.com, but am still completely lost.

Can anyone help me out here?

Thanks!

Keri
 

Attachments

  • 20140205_145459.jpg
    20140205_145459.jpg
    1.6 MB · Views: 74
  • 20140205_145516.jpg
    20140205_145516.jpg
    3 MB · Views: 88

I've seen a smaller 2-wire version of this as a battery connector on one of our cordless phones (a larger, outdated model).

The matching connector encases the connector in your photo.
It has grooves in the sides, to grip the ridges shown in yours.
The pins are square although the openings are rectangular.
I guess that describes half the header connectors out there. Sorry I can't be of more help.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top