Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

need level shifting by 0.1V.... obviously not source follower

Status
Not open for further replies.

sharkies

Member level 5
Member level 5
Joined
Jul 12, 2008
Messages
81
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Visit site
Activity points
2,009
Is there a way to level shift by 0.1V?
It obviously cannot be a source follower since VGS>0.1V.
And I'm not interested in cascadeing a PMOS source follower and a NMOS source follower to obtain voltage difference.
Capacitive level shifting is also not an option...

Is there anything out there?
I've been doing literature search but,, I'm pretty stuck..... :sad:
 

How much circuitry are you willing to tolerate, or create?

In an IC I'd set up a buffer amp with a fixed load current
and a resistor giving the 0.1V drop, and rebuffer that again
to get low output impedance, if this was general purpose
with varying load.
 

I can't imagine any good reason for a 0.1V level shifter. But if Vcc is higher than the Vh level, simply use a pullup resistor of appropriate value. Compute the ESR of the driver from the VI curve and apply ohms law to pull up 0.1V or more.
 
Last edited:

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top