Need help on Voltage output

[kishi]

I'm new to this forum and electronics...
I have a problem with a sensor's output voltage, it is too responsive, how can I reduce it responsiveiness by adding a capacitor?...
it is a 3 wired sensor, one is ground, one is Vin (1-4v), one is 5V..
Please help me.. Thanks1

 

[memsgg]

I am not very clear of your case, a picture is better.

However, you can try to connect a buffer on the output node.

good luck

 

[antonio_eda]

Is it too fast? too sensitive? or the voltage range is too large?

 

[fazan83]

I'm new to this forum and electronics...
I have a problem with a sensor's output voltage, it is too responsive, how can I reduce it responsiveiness by adding a capacitor?...
it is a 3 wired sensor, one is ground, one is Vin (1-4v), one is 5V..
Please help me.. Thanks1

Have you put the pull up resistor to the sensor output?