Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
well...actually, i finally got one inverter circuit that i want..but there is some components on the circuit that i don't understand...what type of resistor does it use?? here is some photos...the one on the red circle...and also, give some advice on improving the circuit design...
but mister_rf..i think the inverter the one i had is perfect for my scholl project...because that it doesn't use any intergrated circuit..(really weak to anything related to IC..lol...sorry)...so please mister_rf, can you tell me what type of resistor it use???...and also thank you for that link....
I had gone through the post. What’s the range of input voltage and output power and which type of resistors are needed according to this circuit ? Please produce some more attachments about the topic for view detail information.
The circuit is protected by a 10 Amp fuse, so there is no reason to use so many output transistors, 4 (two per side) would handle 40 Amps! The .1 ohm resistors are to balance the currents through the parrallelled output transistors, they are wire wound.
Frank
The circuit in post 3 looks like it produces a square wave output. That's OK to power things like heaters and incandescent light bulbs, but a lot of other equipment won't like it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
