Hello every1. I am new to AVR platform. I am using ponyprog and atmega 8.
I didnt set any fuse bits in ponyprog. I have seen in forum that if we wont set proper fuse bits it will damage the IC and it cannot be used for further use.
Can anyone tell me what are the fuse settings in atmega 8 without external crystal?
if you would be using the device with default fuse setting its going to work. if you change the fuses ,then it should properly be done. default fuse setting would be using 1Mhz internal oscilator, Jtag enabled etc if you are ok with it dont change the fuses
if you would be using the device with default fuse setting its going to work. if you change the fuses ,then it should properly be done. default fuse setting would be using 1Mhz internal oscilator, Jtag enabled etc if you are ok with it dont change the fuses
Hello everyone. Thanks for the quick reply. I have programmed the atmega 32 and adjusted the security and configuration bits as attached. I am not able to display anything in uart. I have tried many uart programs but i am able to blink led. Please help
- - - Updated - - -
I am unable to do attach the file. I have done the configuration as in the below link.