Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the key is to use a (binary) counter.
SET/RESET the pulse output at counter = 0
clear the pulse output at counter = pulse width
clear the counter at counter = pulse width.
This should help you to do some drawings (state machine, timing diagram, truth table...whatever you need), then try coding it on your own. Show your ideas, your code ... so we can comment on it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.