Need help for P*tel DXP 2004 error message

[gie_b_hsb]

floating input pins dxp

please guys, how to fixing this error message :
[Error] counter rev.Sch Compiler Signal PinSignal_DSx_1[0] has no driver.

when i create pcb how to build jumper automatically, usually i create only one layer (bottom layer)
thank's all for attention....


:|

 

[Siniša]

dxp error，have no driver

First one it seem syou have some floating input pin or port. Make sure that port or net names match and that input pins are connected somewhere.
As for second, I don't think that Protel is built to do that. Maybe you could go through rules for top layer and force it to perform as you like.

 

[Paul.tian]

First, the input of PinSignal_DSx_1[0] maybe offgrid according this error message.
Second, P*tel can not offer automatic jumper bulid in my experience.
Hope can advise you!