Vlsi_lok
Newbie level 3
Hi all,
The following code snippet when compiled
procedure ApplyReset (signal i_clk: in std_logic
signal i_reset: out std_logic) is
begin
wait until i_clk = '1' ; i_reset <= '1';
wait until i_clk = '1'; i_reset <='0';
end ApplyReset;
The following error message is shown;
near procedure :syntax error
i appreciate your help and time
thanks
lok
The following code snippet when compiled
procedure ApplyReset (signal i_clk: in std_logic
signal i_reset: out std_logic) is
begin
wait until i_clk = '1' ; i_reset <= '1';
wait until i_clk = '1'; i_reset <='0';
end ApplyReset;
The following error message is shown;
near procedure :syntax error
i appreciate your help and time
thanks
lok