Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

NCsim/ Incisive command

Status
Not open for further replies.
L

limitless_21

Member level 2
Member level 2
Joined
May 17, 2012
Messages
52
Helped
1
Reputation
2
Reaction score
2
Trophy points
1,288
Visit site
Activity points
1,668
Hi All,

I am looking for specific commands in the ncsim tool where the user can stop the simulation when it is on going - check the result and start it from the point it had ended the last simulation on.
Will breakpoint work in this tool.

Regards
Limitless
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top