Multisim - Opamp simulation problem -

[mobile-it]

op amp multisim

Hi everyone;

I am trying to simulate the DC working of an OPAMP.

I use the LM741CN in Multisim Version 7.

I have problems with measuring the positive and negative saturation voltage, can someone help me out?

When I build the circuit I get results that are to big to be true... When I build the same circuit with "theoretical 741" everything works fine.

Can someone help me out?

thanks in advance!

 

[mobile-it]

multisim op amp

Can someone please help me out?

thanks

Added after 45 minutes:



**broken link removed**

If you change in this circuit the 741 opamp with LM741CN opamp the circuit doesn't function normal (at the output some kV results... I get results that are bigger then my dc supply can someone help me out?)

thanks in advance!!!

 

[v_c]

multisim op-amp simulation

The opamp model with incorrect results must not have the output voltage clamped to the positive and negative rails (through diodes). I am not too familiar with MultiSim ... is it possible for you to view the model (netlist) of the subcircuit for the malfunctioning opamp. If you can post that model, I might be able to point out where the problem is originating from.

Best regards,
v_c