Y_W
Newbie level 2
Hi,
I build some Momentum components and would like to use them in my ADS schematic simulation. However, I get an error saying that the Momentum component has n-pins, but my schematic has 0-pin. In my schematics, I just set up a S-parameter simulation like how I normally do, with 'terms' connected to the ports of the momentum component. I don't know what went wrong, and would appreciate someone giving me some tips. Thanks.
Y_W
I build some Momentum components and would like to use them in my ADS schematic simulation. However, I get an error saying that the Momentum component has n-pins, but my schematic has 0-pin. In my schematics, I just set up a S-parameter simulation like how I normally do, with 'terms' connected to the ports of the momentum component. I don't know what went wrong, and would appreciate someone giving me some tips. Thanks.
Y_W