Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[Moved] problem of using Momentum component in schematics (ADS co-simulation issue)

Status
Not open for further replies.
Y

Y_W

Newbie level 2
Newbie level 2
Joined
Dec 4, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
14
Hi,

I build some Momentum components and would like to use them in my ADS schematic simulation. However, I get an error saying that the Momentum component has n-pins, but my schematic has 0-pin. In my schematics, I just set up a S-parameter simulation like how I normally do, with 'terms' connected to the ports of the momentum component. I don't know what went wrong, and would appreciate someone giving me some tips. Thanks.

Y_W
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top