alexxx
Advanced Member level 4
IDE=MPLAB X, emulator=ICD3, MCU=pic18f25k20.
As long as the debugger is running the MCU code runs ok. When I press "stop" from MPLAB, the code stops executing. I checked the reset pin and it is ok in '1' state. Also no breakpoints exist. And when I cut the power and then power on (with ICD3 disconnected), again no response.
So what is holding the code and it is not executing without the debugger running?
EDIT: I posted this in the rf section by accident, if a moderator had the kindness to move it to microcontrollers section...
As long as the debugger is running the MCU code runs ok. When I press "stop" from MPLAB, the code stops executing. I checked the reset pin and it is ok in '1' state. Also no breakpoints exist. And when I cut the power and then power on (with ICD3 disconnected), again no response.
So what is holding the code and it is not executing without the debugger running?
EDIT: I posted this in the rf section by accident, if a moderator had the kindness to move it to microcontrollers section...
Last edited: