[moved] Measure the voltage on each net in transistor level schematic using hspice

[question_answer]

Hi all,
I want to set an initial condition for all nodes in a schematic. I know I can do .IC V(net#)=0V one by one. Is there any easier representation that I can give the initial condition to all nodes at once?

And also, if my schematic is huge, I only want to know the voltage values of partial nodes(eg. half of the schematic nodes). How can I do it? ps: use .print V(net#) to print the voltage value of each nodes.

Forget to tell, using hspice

Please help me with the questions, thank you!

 

[question_answer]

Measure the voltage on each net in transistor level schematic using hspice

Hi all,
I want to measure the voltages on each net/wire of a transistor level schematic using hspice. I have the problem on writing the spice netlist. The .print V(nodes) can only print the voltage on input and output. I am not able to write .print(net#), it says the net# can not be recognized as a node. ps: net# is the net/wire where I want to measure the voltage at.

pls help me on the problem, thank you