Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MOSFET Vgs threshold

Status
Not open for further replies.
Z

zhengchao201105

Member level 2
Member level 2
Joined
Jul 11, 2012
Messages
49
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Visit site
Activity points
1,621
BSP149.jpg
refer to the picture attached, if I add a 6v power,why the Vgs value is 0.001v, but according to the datasheet of BSP149, Vgs threshold is -1.4v at typical and minimun -1v.
 

I think your SIM program does not know anything about that unusualdepletion mode Mosfet.
The currents are very low maybe because the drain and source are not connected to anything.
The 13V zener diode is not going to do anything in that 6V circuit.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top