Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

MOSFET High side driver

Status
Not open for further replies.

ismu

Full Member level 2
Full Member level 2
Joined
May 12, 2009
Messages
145
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Location
nil
Visit site
Activity points
2,340
Which one is the best for high side driving IRF2110 or TLP350. and what is the advandage and diffrence between this two chip , i think one is isolated other is not , both are working same principle bootstrap ,
which one best for high voltage with heavy load driving?
 

Hi, When driving fets from a micro, TLP350 Provides better isolation.
however, irf2110 works well with other arrangements.
 

There isn't probably a clear-cut answer to which one is better.
IR2110 probably uses capacitive isolation and is around three to four times faster than TLP350. It also costs more.
TLP350 on the other hand uses optical isolation, is slower than IR2110, but at the same time costs less.
For high frequencies, say above 50KHz, IR2110 should provide better control. For lower frequencies, the difference will probably not be prominent.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top