Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ModelSim waveform printing question

Status
Not open for further replies.
E

ed271828

Junior Member level 1
Joined
Jun 27, 2006
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,385
Is there anyway to set the FONT SIZE for wave form prints? Some values on waves usually get scaled down too much to make them readable.

Thanks!
 

Post this question at mentor's suportnet. I am sure they have a hint for you.
cheers
 

Thanks, but my supportnet account doesn't allow this :p
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top