Hi gianbo85,
Is your SPAPD from Hamamatshu or EG&G or Princenton?
Is these a project at Desy please?
I can not understand your 1 mH need_why is it with for ex. 1-10 uH or so not OK?
You can not apply some "active quenching"?
Then is the veryhighspeed switching of power out of way...
Do you thees script:
https://www.physics.ucsd.edu/~tmurphy/apollo/doc/Dautet.pdf
K.
Added after 4 hours 39 minutes:
Hi gianbo85,
What do you belief please, can be helpful this script four your solution finding?:
"Monolithic active quenching + picosecond timing circuit suitable for large-area single-photon avalanche diodes,
A. Gallivanoni, I. Rech, D. Resnati, M. Ghioni, and S. Cova , Milano":
www.opticsinfobase.org/abstract.cfm?URI=oe-14-12-5021
K.
Added after 57 minutes:
As biff44 spoke over that too:
The LMH6533 laser-diode driver (not the highest speed) features switching rates of less than 0.8 nsec and contains two high-current outputs for reading and writing 650-nm DVD or 780-nm CD lasers. It achieves read, write, and erase ...
And what about :
AVX, MultiGuard multilayer ceramic transient voltage suppression arrays-or similar products?
For ex. the AVX "Transfeed" transient voltage suppressors have 200-250psec respond times
Please refer to side 41:
www.mouser.com/catalog/supplier/library/pdf/AVXTVS.pdf
I can remember over some similar high speed Comm-line semiconductor transient suppressor diode-arrays from Vishay too...
K.