flames4791
Junior Member level 3
Hi, I am designing a mixer for a bluetooth radio transmitter for a school project. I am having trouble figuring out how to run simulations for the following specs that I have to meet.
Gain = 0dB
Do I just connect one port at input and one port at output and use sp analysis to measure s21?
OIP3 => -5dBm
I have this simulation for the power amplifier, and I just have a port at input and port at output. Then I run a PSS analysis for the compression point. Is this correct?
These new two I really don't know.
Image reject ratio = 25dB
LO to RF leakage = -40dB
Any tips, advice, or references would be greatly appreciated! Thanks for your time!
Gain = 0dB
Do I just connect one port at input and one port at output and use sp analysis to measure s21?
OIP3 => -5dBm
I have this simulation for the power amplifier, and I just have a port at input and port at output. Then I run a PSS analysis for the compression point. Is this correct?
These new two I really don't know.
Image reject ratio = 25dB
LO to RF leakage = -40dB
Any tips, advice, or references would be greatly appreciated! Thanks for your time!