greg12345
Junior Member level 3
cst low frequency
Hi
I have seen a lot of opinions about CST or HFSS, but I need a new one about microstrip design for frequencies up to 10GHz and for wideband simulations
We plan to buy an EM software and I want to make the good choice for our design.
Our structures are often for antennas, filters, printed inductors (size of elements very little in compare to frequency)..., at 868MHz, 2.4GHz,...
I would like to use a lumped elements inside EM simuladtions (lumped element in CST).
In my opinion I find CST easier than HFSS and it uses less memory for simulation. In V5 the meshing become good, and the updating meshing is similar than HFSS.
Thank
Greg
Hi
I have seen a lot of opinions about CST or HFSS, but I need a new one about microstrip design for frequencies up to 10GHz and for wideband simulations
We plan to buy an EM software and I want to make the good choice for our design.
Our structures are often for antennas, filters, printed inductors (size of elements very little in compare to frequency)..., at 868MHz, 2.4GHz,...
I would like to use a lumped elements inside EM simuladtions (lumped element in CST).
In my opinion I find CST easier than HFSS and it uses less memory for simulation. In V5 the meshing become good, and the updating meshing is similar than HFSS.
Thank
Greg