chittads@yahoo.com
Newbie level 6
what value we find from z parameter result of antenna ?
Welcome to EDAboard.com
Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
microstrip antenna design using ie3d
- Thread starter chittads@yahoo.com
- Start date
- Status
sv1437
Full Member level 6
You will find the input impedance of the feed line or port which you used to connect to the microstrip patch antenna. If you normalized the impedance of the feedport, then you will see 50 ohms, otherwise you should see a different value.
- Status