moez
Newbie level 6
Hi Everyone,
I purchased a steeper motor ( PH533HG2-NA) along with its driver ( UDX5107N).
Motor rotates single step by giving it a single pulse through driver, but to increase its accuracy want it to move in micro steps.
Is this possible with model ?
If it is, then how would it be done?
Regards
Moez
I purchased a steeper motor ( PH533HG2-NA) along with its driver ( UDX5107N).
Motor rotates single step by giving it a single pulse through driver, but to increase its accuracy want it to move in micro steps.
Is this possible with model ?
If it is, then how would it be done?
Regards
Moez