Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Mechanical hole placement in Altium design

Thread starter viperpaki007
Start date Aug 7, 2014

Status: Not open for further replies.

Aug 7, 2014

#1

V

viperpaki007

Full Member level 5

Full Member level 5

Hi,

How can i put a mechanical hole in PCB using altium designer.

regards

Aug 7, 2014

#2

andre_luis

Super Moderator

Staff member

Advanced Member level 7

you can draw a Pad with no metalization; in other words, could perform this by specifying a metalization diameter smaller than hole size.

Status: Not open for further replies.

Similar threads

Z
Altium Designer - NC Drill File Name Extensions
- Started by zildjiansplaash
- Nov 4, 2024
- Replies: 0
PCB Routing Schematic Layout software and Simulation programs
Y
exporting cloud based project in Altium
- Started by yefj
- May 31, 2024
- Replies: 0
PCB Routing Schematic Layout software and Simulation programs
P
Altium making special shapes on PCBs
- Started by Pixelx
- Oct 2, 2024
- Replies: 3
PCB Routing Schematic Layout software and Simulation programs
C
Unrouted net issue when design rule check in Altium
- Started by cupoftea
- Jan 11, 2024
- Replies: 0
PCB Routing Schematic Layout software and Simulation programs
Y
Problem understanding PAD properties in ALtium menu
- Started by yefj
- May 24, 2024
- Replies: 2
PCB Routing Schematic Layout software and Simulation programs

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.

Accept Learn more…

Top