Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Measuring main voltage - Which sensor to use?

Status
Not open for further replies.

rprodrigues

Member level 2
Joined
Nov 18, 2006
Messages
49
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Itajubá MG Brazil
Activity points
1,653
sensing mains voltage

Hello all,

I need to measure main voltage (110V / 220V) but I can't use a voltage divider (with resistors) because of an isolation requeriment.

Which voltage sensor should I use? Any suggestions?

I know LEM have some, but they are too expensive.



Thank you!
 

voltage sensor site:www.edaboard.com

A small transformer (print transformers are available starting from 0.3 VA) is the most economic AC voltage isolation solution.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top