bcao3
Newbie level 1
Matlab has below D-statcom control example.
**broken link removed** ... -average-model.html
In situation of voltage regulation, I set up the input voltage has +/-0.2pu changes, but I found out the voltage regulation output is not as good as expected. The result has obvious steady state error. You can refer to the attached picture for more information.
I found that the D-Statcom is 3Mvar, maybe I need to increase D-Statcom power, but I can not figure out how to do it.
Can anyone give me some suggestions?
Thanks!
**broken link removed** ... -average-model.html
In situation of voltage regulation, I set up the input voltage has +/-0.2pu changes, but I found out the voltage regulation output is not as good as expected. The result has obvious steady state error. You can refer to the attached picture for more information.
I found that the D-Statcom is 3Mvar, maybe I need to increase D-Statcom power, but I can not figure out how to do it.
Can anyone give me some suggestions?
Thanks!