Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Matlab D-Statcom example control problem

Status
Not open for further replies.

bcao3

Newbie level 1
Joined
May 9, 2015
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
Matlab has below D-statcom control example.

https://www.mathworks.com/help/ph ... -average-model.html

In situation of voltage regulation, I set up the input voltage has +/-0.2pu changes, but I found out the voltage regulation output is not as good as expected. The result has obvious steady state error. You can refer to the attached picture for more information.

I found that the D-Statcom is 3Mvar, maybe I need to increase D-Statcom power, but I can not figure out how to do it.

Can anyone give me some suggestions?

Thanks!


Question_dstatcom_3.jpgQuestion_dstatcom_1.jpgQuestion_dstatcom_2.jpg
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top