tv repair panasonic
Thanks for the replies guys. Sorry that it took me so long to get back to the topic. I thought I've posted the reply already.
...
I've partially fixed the TV.
Moving the cables seemed to bring or kill
the picture, so I figured that it might be bad contact issue. I took
out the board, examined all the connectors, reseated them, but that
didn't help. Also, trying to touch the components with a pencil didn't
do anything to the picture. However, when I've flipped the board, I
found out that one of the joints was missing solder from it. Maybe it is a problem that
arrised during the manufacturing or maybe it's me moving about 4 times
in the past 6 years (University and other). I've isolated the
solder with an electric tape and fixed the connection. As a result,
the TV went back to normal.. for several days.
Now it gives me similar problem. Moving
the cable socket that is connected to the board inside seems to bring
the picture back. So, it's possible that my solder came off as well or there's something else. As a temporary
fix, I've applied the tention on the cable by placing it under TV.
I'll address the problem later.
My iron is only 15-30W, which I think should be enough.
Thanks,
Victor