Dear sabkumar,
As you've said there can be many way to do that (by the way, I've used Blastfusion, but as far as I know many commands are similar):
1 - report model $m -file report_model.rpt
- It has a lot information on the design
- or you can use similar approach in item 2.
2 - As you said loop over all the cells like below:
data loop c "model_cell_leaf -cell_type macro" $m {
set ma [data only cell_model $c]
puts "$ma : $c"
}
You can play with the cell_type option.
By the way if you would like to know which relations exists, just run: "data relation". this will give you a lot of relations related to objects (e.g. cells, nets, ...)
3 - Again "report model" will have some information on logic nets.
I hope it helps,
Gökhan
---