fa_a2z
Newbie level 6
before anything, i would like to make a few clarification:
1. i am new to this forum
2. i am not sure if this is the correct section, sorry if its wrong
ok,
i've just made a proposal to make a project which requires the integration of gsm module and wifi module and the requirement is it need to be low cost. i believe i have just dug my own grave since i just realize that the modules were quite expensive.
the project details were as follows:
1. the project aims at developing a system that controls a control panel using mobile phones.
2. the system need to be able to distinguish between different mode of operation (if its within wifi range, switch to that mode, otherwise use gsm mode)
3. the system will be developed for symbian and android platform.
4. the control panel consist of a microntroller, set of sensors and monitoring devices, gsm and wifi modules. the phone will be able to control all these things in a GUI environment.
5. tools to be used: c18 for compiler,proteus for simulation, eclipse for symbian applications.
the problem: anyone things that this is insane/out of track? if this project is ok, can anyone suggest a low cost method of integrating the modules in one board?
1. i am new to this forum
2. i am not sure if this is the correct section, sorry if its wrong
ok,
i've just made a proposal to make a project which requires the integration of gsm module and wifi module and the requirement is it need to be low cost. i believe i have just dug my own grave since i just realize that the modules were quite expensive.
the project details were as follows:
1. the project aims at developing a system that controls a control panel using mobile phones.
2. the system need to be able to distinguish between different mode of operation (if its within wifi range, switch to that mode, otherwise use gsm mode)
3. the system will be developed for symbian and android platform.
4. the control panel consist of a microntroller, set of sensors and monitoring devices, gsm and wifi modules. the phone will be able to control all these things in a GUI environment.
5. tools to be used: c18 for compiler,proteus for simulation, eclipse for symbian applications.
the problem: anyone things that this is insane/out of track? if this project is ok, can anyone suggest a low cost method of integrating the modules in one board?