f6iib said:I had some insights from someone who knows much much better than me .... lol
so I quote
"assume that 10 mhz 1vpep input to rear osc
and set switch to ext input did not work....
next job verify 10 mhz output at rear. check with freq counter
1 khz at 2v / 400hz at 2v check with dvm ac setting
Reading after 20 mins should be 2.00v +- 25mv
Press init to reset unit should read 100mhz @ -30dBm
Error flashing 80
Tune freq to 150mhz check if error goes
Tune to freq 600mhz check again
The error will auto go if unit correct??
If no change?? check rear switch working ok
If not happy change switch if unsure change switch"
I didn't have the time to try this out
hope this could help others
f6iib said:Could you post pictures of your rig
sealed unit inside ....
Front side as well
regards
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?