Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

load pulling in cadence virtuoso

Thread starter praveen450
Start date Mar 3, 2014

Status: Not open for further replies.

Mar 3, 2014

#1

P

praveen450

Member level 5

Member level 5

How can I perform load pulling in cadence virtuoso?.

Mar 7, 2014

#2

N

natnoraa

Full Member level 1

Full Member level 1

Hi,

This will help you:
http://www.cdnusers.org/community/virtuoso/resources/SpectreRF_PA533AN.pdf

Natnoraa

Status: Not open for further replies.

Similar threads

B
PHEMT AMP LOAD line ADS
- Started by Bailey_NTF
- Nov 27, 2024
- Replies: 4
RF, Microwave, Antennas and Optics
M
Load-Pull with diodes for a SHM
- Started by martinez96
- Jun 13, 2024
- Replies: 0
RF, Microwave, Antennas and Optics
T
Load pull testing transceiver LNA input, impedance tuner DIY alternative
- Started by tretmax
- May 19, 2024
- Replies: 5
RF, Microwave, Antennas and Optics
S
Circulator Modelling in Cadence Virtuoso
- Started by soi34
- Jan 6, 2023
- Replies: 2
RF, Microwave, Antennas and Optics
N
How to do PA Load Pull Analysis for Wide Band Frequencies using ADS
- Started by narayani
- Mar 12, 2024
- Replies: 1
RF, Microwave, Antennas and Optics

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.

Accept Learn more…

Top