ashhadb
Newbie level 4
how can i optimize input LNA match in momentum or after layout craeted . . . . .
as a schematic the match works f9, when i make the layout and put it there the results differ very very widely
i have separated the input match , how can i optimize it ,
now i have this setup
term=50ohm---------input match --------term=15.14+j42.4 ohm
i check the s parameters of both the scematic microstrips and the component strips from the layout .... . . .. . . just how can i fix this . . .
as a schematic the match works f9, when i make the layout and put it there the results differ very very widely
i have separated the input match , how can i optimize it ,
now i have this setup
term=50ohm---------input match --------term=15.14+j42.4 ohm
i check the s parameters of both the scematic microstrips and the component strips from the layout .... . . .. . . just how can i fix this . . .