amorim317
Newbie level 1
- Joined
- Mar 11, 2015
- Messages
- 1
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1
- Activity points
- 9
hello guys,
i have spent some time trying to figure out how lattice baluns works, i could notice that we need equal values for caps and inductors for 180 phase goal, the problem is that when you match a leg, let´s say the "low pass leg" the "high pass leg" will not be matched with just exchanging cap and inductor position...
i used **broken link removed** this cc2500 circuit as a study case.
At the datasheet they say the balanced side has a 80+j74 Ohms impedance so what i did, was to take the half, 40+j34 ,and tried to play with, but had no sucess with the second leg..
any tips?
Ps: i tried to match 40+j37 with 20 Ohms as they do at the swra236a.pdf
thank you!
i have spent some time trying to figure out how lattice baluns works, i could notice that we need equal values for caps and inductors for 180 phase goal, the problem is that when you match a leg, let´s say the "low pass leg" the "high pass leg" will not be matched with just exchanging cap and inductor position...
i used **broken link removed** this cc2500 circuit as a study case.
At the datasheet they say the balanced side has a 80+j74 Ohms impedance so what i did, was to take the half, 40+j34 ,and tried to play with, but had no sucess with the second leg..
any tips?
Ps: i tried to match 40+j37 with 20 Ohms as they do at the swra236a.pdf
thank you!
