plz help me,i m using L293d ic to drive 12V dc geared motor , but i m getting very low output voltage of only 1.5V , even in input voltage i give 12V
n digital input by microcontroller ,so plz tell me how to get 12V at otput
plz help me,i m using L293d ic to drive 12V dc geared motor , but i m getting very low output voltage of only 1.5V , even in input voltage i give 12V
n digital input by microcontroller ,so plz tell me how to get 12V at otput
Check your schematic. Ensure the Enable pin of the respective bridge is high. Ensure the pin 8 is connected to 12V and ensure your using the right logic to run the motor.