askar_
Newbie level 1
Hi all,
I'm having trouble in reading data through serialport using software developed in Qt (C++). Now i'm working for microcontroller - PC communication through serial port.
The case is, if i booted my PC (WinXp) when i tried to read data through serial port using software developed in Qt (C++), it reads junk char's repeatedly, but if i tried to read the same in Hyperterminal (or) SIOW software it reads properly.
After using Hyperterminal or SIOW to read data one time, my sofware (developed in Qt (C++))also reads the data properly (same program).
settings are all same on both ends.
I suspect that, other than serial port initialization parameter settings , i need to configure something else in my PC side...
Let me know where im doing wrong...
Thanks in advance
Regards,
--------
Askar Ali.
I'm having trouble in reading data through serialport using software developed in Qt (C++). Now i'm working for microcontroller - PC communication through serial port.
The case is, if i booted my PC (WinXp) when i tried to read data through serial port using software developed in Qt (C++), it reads junk char's repeatedly, but if i tried to read the same in Hyperterminal (or) SIOW software it reads properly.
After using Hyperterminal or SIOW to read data one time, my sofware (developed in Qt (C++))also reads the data properly (same program).
settings are all same on both ends.
I suspect that, other than serial port initialization parameter settings , i need to configure something else in my PC side...
Let me know where im doing wrong...
Thanks in advance
Regards,
--------
Askar Ali.