Is it possible to design a single layer PCB in Altium?

[pradeep_k_b]

Hi,I am trying to make single layer PCB for my project.I have been using Cadsoft eagle for my previous projects but now I would like to try Altium and I have installed Altium in my computer,but when I try to set 'Layer stack manager' it seems there is no option for single layer PCB,the minimum is two layer.I need to design a single layer PCB,because I am using toner transfer method for PCB fabrication,it wont work with multilayer.Is there any possibility to design a single layer PCB in Altium?

 

[kabaleevisu]

hi,
you can do single layer board in altium.don't route any signal in top layer you should route in bottom layer only.For Fabricator you should send Bottom layer routing ,Top-Silkscreen,Soldermask bottom and Drill table it is enough.

 

[pradeep_k_b]

Okay..Let me try this..thank you