Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Inveeter pair removal using RTL Compiler

Status
Not open for further replies.

Resistance

Member level 4
Joined
Dec 24, 2005
Messages
74
Helped
5
Reputation
10
Reaction score
2
Trophy points
1,288
Activity points
2,034
inveeter

Hi,

Am working on a code to remove Inverter pairs.
I have successfully located them and correctly disconnected and reconnected the nets but I have problem removing more than one pair .. Can any one of u help .. then i will post my code..

Actually i have list of invertes in the design.
Then i pick up two inv to be removed and remove them but how to keep updating my list...

rm does not work..

Any body can help.

regards
 

elecs_gene

Member level 2
Joined
Dec 20, 2005
Messages
52
Helped
3
Reputation
6
Reaction score
1
Trophy points
1,288
Activity points
1,797
hi
before starting the search ,remove all the buffers first .then,take a particular cell..check its inverter attrbute..if true,then check the net attr of any of its pin(ip or out)..if its driver(ip)/load(out) gives u a inverter then disconnect the inverters and then connect them.now remove the pair.....what do u mean by saying that list doesn't get updated or something???
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top