Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Firstly, which voltage of reference you'll be used?
because if supply voltage (Vdd) you'll must do a voltage divider (I think that it's good idea), or if not, you must connect appropriate voltage to Vref+, Vref-.
If you select Vref = Vdd, you can connect pin W:Vout in the SY-HS with pin ANx in the PIC (x is noumber of port, for example: AN0, AN1, AN2...) by voltage divider.
In SY-HS B it's GND and R is Vcc 5V.
I don't written how connect supply to PIC because I think that it you know.
Regards
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
