smartsarath2003
Member level 4
Hello,
I am just started using the CY3201-PD development kit for CY 26443 Psoc device.I just made a simple circuit board with a 7 segment display,programming header,9 pin d type connector and a reset circuit.So far I just programmed the PSoC and placing it on my circuit board. I want to connect it to ICE by using a RJ45 connctor->9pin d type connector.Will I able to use my circuit board in the same way as like the POD,instead of using POD itself. My Intension is to have software control on the circuit board, sothat I can debugg my program by step throughing it.Also How can I able to know the Pin Outs of RJ45 connector from ICE. I don't know which of the lines arebeing used now. I didn't able to get that information on Cypress website. Can any one please help me with these Issues Please........
Thanks
Sarath
I am just started using the CY3201-PD development kit for CY 26443 Psoc device.I just made a simple circuit board with a 7 segment display,programming header,9 pin d type connector and a reset circuit.So far I just programmed the PSoC and placing it on my circuit board. I want to connect it to ICE by using a RJ45 connctor->9pin d type connector.Will I able to use my circuit board in the same way as like the POD,instead of using POD itself. My Intension is to have software control on the circuit board, sothat I can debugg my program by step throughing it.Also How can I able to know the Pin Outs of RJ45 connector from ICE. I don't know which of the lines arebeing used now. I didn't able to get that information on Cypress website. Can any one please help me with these Issues Please........
Thanks
Sarath