Input match of a CS-LNA considering the bondwire and pad

[lsfeng]

now I am designing a common source LNA ,and the S11 is very bad(-7,8dB),I want to make it better by improve the
input match network.Considering the effect of bondwire and pad of input signal,the quetion seems more difficult to me，the schematic is as follows ,how can I make an input match network to achieve both a good S11 and NF at the same time ,thank you!

ps: the book " microwave egineer" is usefull for RF designing?

 

[khouly]

the source degenration inductor used to increasee the real part of the input impedance , while the gate inductor used to eleimtae the imaginary capacitive part , but u have another section u need to know how this section affect the input imedance of ur circuit , then re design the Ls and Lg to give u the best result

sure if u read about matching circuits in microwave books will be very usefull

khouly

 

[lsfeng]

thank u very much for ur advise ,i think i should learn more theory about matching firstly,
any how it becomes more complicated consideing the effect of bondwire and pad of input, output,gnd and vdd,and my circuit is working on 3-5GHz, it's really awful things!!!

 

[khouly]

sure the multi Ghz RFIC , these effects of bondwires and pads must be taken into account ,

u need to check how the bondwire intuctance will affect the impedance

khouly

 

[rajivpanigrahi]

May i know what are the books for matching network concept...Please kindly tell me...