Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the image rejection ratio is the ratio between the IF power from the desired signal to the IF power from the image , when the desired siangl and image have the same input power
For calculating the image rejection ratio in ADS, we give two signals as system input, "original signal" and the "image signal + 10Khz ".
In my receiver I am down converting my signal to 20Mhz. So for calculating IRR, What i have to do ?
Shall i take peek difference of "20Mhz" and "20Mhz +10Khz" or 0Hz and 10Khz?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
