on the edge of the PCB if u make something like this
View attachment 90305
View attachment 90306
View attachment 90307
use some mating connector something like this
View attachment 90308
something like this u can extract from Mobile components.
during programming keep press it (no need to insert). that's enough.
still if u need some more ideas pls let us know.
Just use exising through hole component legs or tiny pads and use spring loaded PCB probes. The probes push against the pads/legs and are connected to the Pickit not the PCB itself. If you are making large quantities, build a simple jig to hold the probes and locate the board over them. It takes only a few seconds then to program each board. I've done this with PCBs with 1,000+ test connections so a Pickit should be very simple.
Just use exising through hole component legs or tiny pads and use spring loaded PCB probes. The probes push against the pads/legs and are connected to the Pickit not the PCB itself. If you are making large quantities, build a simple jig to hold the probes and locate the board over them. It takes only a few seconds then to program each board. I've done this with PCBs with 1,000+ test connections so a Pickit should be very simple.
I make using connectors POGO PINS in a JIG of acrylic.
I do in PCB TEST-POINTS (small solder points).
like this **broken link removed**
You might also consider this ready-made ICD adaptor **broken link removed**
The POGO PIN don't have only one type!!!
Have various types.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?