Neha Anu
Junior Member level 1
Hi all,
While creating .ibs file to .dml file in the PCB SI Editor, the conversion was stuck at one point and an error occured ie,the file cannot be translated to .dml.:roll:
On checking the log file,I came across majority of warnings such as "Typical data is non-monotonic"
Can any one explain why the translation is aborted and is there any solution to this?
Thanks in advance,
While creating .ibs file to .dml file in the PCB SI Editor, the conversion was stuck at one point and an error occured ie,the file cannot be translated to .dml.:roll:
On checking the log file,I came across majority of warnings such as "Typical data is non-monotonic"
Can any one explain why the translation is aborted and is there any solution to this?
Thanks in advance,