eduard.el
Newbie level 1
Hi.
I have remote control project using Atmega8 micro controller.
On receiver side I shuld control 10 lamps independently via triac.
For that purpose I need 10 independent dynamic PWMs using single Atmega8.
I have one interrupt coming from AC voltage, it is needed for synchronization purposes. The second one is coming from receiver side (when the packet is received).
So is it possible to drive this 10 pwms related to received packet data.
Thank you a lot ! ! !
I have remote control project using Atmega8 micro controller.
On receiver side I shuld control 10 lamps independently via triac.
For that purpose I need 10 independent dynamic PWMs using single Atmega8.
I have one interrupt coming from AC voltage, it is needed for synchronization purposes. The second one is coming from receiver side (when the packet is received).
So is it possible to drive this 10 pwms related to received packet data.
Thank you a lot ! ! !