siber222000
Newbie level 1
- Joined
- Jul 28, 2014
- Messages
- 1
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1
- Activity points
- 10
Hello everyone,
HSPICE newbie here and I just had a quick question regarding the temperature variance on netlist.
Question is basically how can you change the temperature during the simulation?
For example, at time 0ns I wish to simulate at temperature 30 Celsius, but then at time 700ns of the same simulation I wish to change that temperature to 90 Celsius! I did read some .dc analysis commands where you can sweep temperature, but I wish to do this in .tran analysis.
Also, .alter command would not work in my case because that would start a entirely new simulation.
Any replies would be very helpful,
Thank you very much!
Sincerely,
HSPICE newbie here and I just had a quick question regarding the temperature variance on netlist.
Question is basically how can you change the temperature during the simulation?
For example, at time 0ns I wish to simulate at temperature 30 Celsius, but then at time 700ns of the same simulation I wish to change that temperature to 90 Celsius! I did read some .dc analysis commands where you can sweep temperature, but I wish to do this in .tran analysis.
Also, .alter command would not work in my case because that would start a entirely new simulation.
Any replies would be very helpful,
Thank you very much!
Sincerely,
